I’m looking for an expert to design standalone Microgrid system (using Matlab/ Simulink) for a rural area for a location in Saudi Arabia (As Suwadirahhttps://goo.gl/maps/8KMEiivxGDMeY3mA8 )with specific loads.The system will contain a PV with a specification (I will include the data sheet) and Energy storage. the PVpanel moves by two servo motors facing the highest intensity of sunlight captured by LDRsensor to track the sun’s movement by using fewer componentsand low-cost as well. Make a comparison based on experimental resultsbetween the energy produced by the proposed tracking system and a fixed panel and showthat tracking system produces ….. more energy compared to the fixed panel.Load profiles are 1- Residential. 4,500 w2- school ???? 5000 w3-Farm 10000 w4- small factory 15000 wMaximum Power Point Tracking system will be used to track the SUN there will be 4 light-dependent resistor sensors attached to the solar panels and motors. Also, the initial value of our system (tracking sys) we want to make sure the panel go back from west to East after the sunset. Attach all codes with original graphics results. should be run in Matlab/ Simulink. Use at least 40 references minimum.The methodology included following:-Sizing of the system with clear mathematical modeling -Optimization type which is Linear programming must be used to maximize the output power for excellent system performance even with shading effect such a dust and clouds.The system also includes a transmission line and breakers between the energy source and loads.I’m looking for an expert to design a standalone Microgrid system (using Matlab/ Simulink) for a rural area for a location in Saudi Arabia (As Suwadirahhttps://goo.gl/maps/8KMEiivxGDMeY3mA8 )with specific loads.The system will contains a PV with a specification (I will include the datasheet) and Energy storage. Load profiles are 1- Residential. 4,500 w2- school ???? 5000 w3-Farm 10000 w4- small factory 15000 wMaximum Power Point Tracking system will be used to track the SUN there will be 4 light-dependent resistor sensors (LDRs) attached to the solar panels and motors. Also, regarding the initial value of our system (tracking sys), we want to make sure the panel goes back from west to East after the sunset. Attach all codes with original graphics results. should be run in Matlab/ Simulink. Use at least 40 references minimum.The methodology included following:-Sizing of the system with clear mathematical modeling -Optimization type which is Linear programming must be used to maximize the output power for excellent system performance even with shading effects such a dust and clouds.The system also includes a transmission line and breakers between the energy source and loads.Our controller is also able to shut down the panel that it has dust without losing all the powerTo display the input and output (voltage, current, frequency and power) a display and scope devices must be used.paper research must have1- Abstract2-INTRODUCTION3- Related to work4-Problem Identification5-System Specification6- methodology7-Power data acquisition system8- Result and Discussion9-CONCLUSION10-REFERENCESdeliverables:Source codescreenshots of outputsDocumentationDetailed report
